The SecureCRT tool cannot input commands and the Enter key cannot be used. Solution

Reading volume: 1
Updated on May 27, 2021

First, confirm if the baud rate is correct, and then remove all the hooks on the right side

Follow up
The baud rate has been confirmed to be 9600, and the RTS check box has also been removed. There is no response when entering the key, and there is no response when entering the command


Related news
More>>
Mac系统驱动安装 Mac system driver installation
01 .08.2025
Most of the time, when you install Arduino on Mac OS X, the drivers are installed automatically. How,true}
SecureCRT连接思科交换机 SecureCRT connected to Cisco switch
01 .07.2025
Under XP, the built-in tool "HyperTerminal" can be used directly, but on Win7 or later versions, SecureCRT needs to be downloaded and installed. This article assumes that SecureCRT has already been downloaded and installed. Firstly, connect the computer to the console cable. Because many laptops currently do not have serial ports configured, the console cables are all simultaneously, true}
PL2303非原装旺玖提示解决方法 PL2303 Non original Wangjiu Tip Solution
07 .12.2024
Pinduowei specializes in producing customized serial port cables FTDI CABLE USB RJ45 CONSOLE DB9 RS232 RS485 RS422 serial port cables. Welcome to visit the factory and discuss cooperation, true}
MAC驱动安装 MAC driver installation
03 .14.2024
Pinduowei specializes in producing customized serial port cables FTDI CABLE USB RJ45 CONSOLE DB9 RS232 RS485 RS422 serial port cables. Welcome to visit the factory and discuss cooperation, true}

Leave your information